Functional Description - Makita DTW450 Bedienungsanleitung

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before adjust-
ing or checking function on the tool.
Installing or removing battery cartridge
► Fig.1: 1. Red part 2. Button 3. Battery cartridge
• Always switch off the tool before installation or
removal of the battery cartridge.
• To remove the battery cartridge, withdraw it from
the tool while sliding the button on the front of the
cartridge.
• To insert the battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Always insert it all
the way until it locks in place with a little click. If
you can see the red part on the upper side of the
button, it is not locked completely. Insert it fully
until the red part cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
• Do not use force when inserting the battery car-
tridge. If the cartridge does not slide in easily, it is
not being inserted correctly.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.2: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Downloaded from www.Manualslib.com
Indicator lamps
Off Blinking
manuals search engine
Switch action
► Fig.3: 1. Switch trigger
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
• Change the direction of rotation only when the
tool comes to a complete stop. Changing it
before the tool stops may damage the tool.
The switch is reversible, providing either clockwise or coun-
terclockwise rotation. To start the tool, simply pull the lower
part (A) of the switch trigger for clockwise or the upper part
(B) for counterclockwise. Release the switch trigger to stop.
Lighting up the front lamp
► Fig.4: 1. Lamp 2. Lamp switch
CAUTION:
• Do not look in the light or see the source of light directly.
Push the upper position of the lamp switch for turning
on the light and the lower position for off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• The light is provided with anti excessive dis-
charge circuit. When the lamp does not light up
even after the light switch is turned on, there is
likely to be battery power drop. Try to charge the
battery cartridge.
• Keep the lamp switch in "off" position while not
in need of the light.
ASSEMBLY
Remaining
capacity
CAUTION:
• Always be sure that the tool is switched off and
75% to 100%
the battery cartridge is removed before carrying
out any work on the tool.
50% to 75%
Selecting correct socket
25% to 50%
Always use the correct size socket for bolts and nuts. An
0% to 25%
incorrect size socket will result in inaccurate and inconsis-
tent fastening torque and/or damage to the bolt or nut.
Charge the
Installing or removing impact socket
battery.
The battery
Country specific
may have
malfunctioned.
CAUTION:
and the mounting portion are not damaged before
installing the impact socket.
CAUTION:
make sure that it is firmly secured. If it comes out,
do not use it.
6 ENGLISH
Make sure that the impact socket
After inserting the impact socket,