Operating Modes; Faults - HEYLO DE2XS Betriebsanleitung

Operating mode
c) Move the
0 position.
During prolonged downtime: Pull out the mains
plug.
 You have now switched off the device.
See also
 Malfunctions during operation
18.2

Operating modes

The operating mode can be used to select the heat-
ing output. The device emits the intake air in heated
form (Heat 1000 W or Heat 2000 W).
The operating mode can only be selected with the
Operating mode
rotary selector.
Operating mode Heat (1000 W)
Operating mode
– Move the
sition 2 (Heat 1000 W).
– The fan and the heater are switched on and are
conveying and heating up the intake air.
– The desired temperature is set with the
temperature
rotary knob.
NOTICE
Single-sided warming of the heating element
In the 1000 W mode, one half of the heating ele-
ment remains cooler than the other half. This is a
normal operating condition.
Operating mode Heat (2,000 W)
Operating mode
– Move the
sition 3 (Heat 2,000 W).
– The fan and the heater are switched on and are
conveying and heating up the intake air.
– The desired temperature is set with the
temperature
rotary knob.
EN
rotary selector to the
[ 30]
rotary selector to po-
Heating
rotary selector to po-
Heating
19

Faults

Observe the following principles if you looking for the
causes of faults and want to eliminate them:
These tasks may only be carried out by trained and
authorised specialists.
Interventions may only be carried out by the manu-
facturer or by persons authorised by the manufac-
turer during the statutory warranty period.
a) Let the device cool down.
b) Wear suitable protective clothing.
c) Before recommissioning, install all the safety
devices as attached at the factory.
d) Check that the safety devices are functioning
properly.
e) After completing the task, remove all the tools
and objects from the working area around the
device.
Safety instructions regarding faults
DANGER
Electric shock arising from high voltage when
working on the electrical components
Electric shock can cause serious injury or death.
a) Any work on the electrical system must be per-
formed by qualified electricians only.
b) Disconnect the device from the power supply
before performing any work on the electrical
system.
c) After completion of the work, install all protec-
tive equipment as provided at the factory.
Electric heater DE2XS
29 / 34