Operation; Operation Instructions - Zipper Maschinen ZI-LBR40V-AKKU Betriebsanleitung

14

OPERATION

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
The batteries are not fully charged on delivery. Prior to initial operation, charge the batteries
fully. See user manual of the battery charger.

14.1 Operation instructions

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
 Unplug battery and safety switch (if equipped) before all maintenance and
settings and cleanings!
 Insert the safety switch only when using the machine.
 Never remove the battery while the machine is running.
 If the power tool is damaged or vibrates unusually, it must be repaired by a
service centre before it is used again.
14.2 Operation
Installing/removing the blow pipe:
Tools are not required to install the blower pipe.
 Attach the blow pipe into the connecting piece and
secure by turning it in clockwise direction (bayonet
catch engages).
 Proceed the removal in reverse sequence to
installation.
 Open retaining hook and hook onto the fastening eye
on the housing.
 Adjust the shoulder belt to your height.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-LBR40V-AKKU
N O T I C E
W A R N I N G
OPERATION
26