Operation; Operation Instructions; Adjustments Before Using - Zipper Maschinen ZI-HET40V-AKKU Betriebsanleitung

13

OPERATION

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
The batteries are not fully charged on delivery. Prior to initial operation, charge the batteries fully. See user
battery charger.
manual of the

13.1 Operation instructions

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
 LUBRICATING THE CHAIN: The machine may be operated with adequate chain
lubricating oil only
 CHAIN TENSION: Must be checked before each use!
 Unplug battery and safety switch (if equipped) before all maintenance and
settings and cleanings!
 Insert the safety switch only when using the machine.
 Never remove the battery while the machine is running.
 If the power tool is damaged or vibrates unusually, it must be repaired by a
service centre before it is used again.

13.2 Adjustments before using

Chain oil:
 Check the amount of oil on the oil level
indicator.
ATTENTION:
 Fill the oil tank only with an environmentally
compatible quality chain and bar lubricant.
 Do not use waste oil. Renewed contact with waste oil
can cause skin cancer. Waste oil is environmentally
harmful. Waste oil does not have the necessary
lubricating properties and is unsuitable for chain
lubrication.
 An oil other than the one recommended may damage
the rail, the chain and the lubricating system.
 Ensure that dirt does not get into the oil tank.
 Avoid spilling oil. Always wipe up any spilled oil.
Topping up:
 Open the oil tank cover (a).
 Before opening, clean if required.
 Carefully pour in the chain lubricating oil until it
reaches the upper mark on the oil level indicator
(b).
 Close the oil tank cover (a).
 Check the chain oil level even during operation and
top up with chain oil if required
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HET40V-AKKU
N O T I C E
W A R N I N G
OPERATION
30