GreenWorks 2504807 Bedienungsanleitung Seite 5

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
Stop the machine, and remove battery pack.
Make sure that all moving parts have come to a
complete stop. Failure to comply could result in ac-
cidental starting and possible serious personal injury.
If any parts are damaged or missing do not operate
this product until the parts are replaced. Using a
product with damaged or missing parts could result
in serious personal injury.
INSTALLING THE LOWER HANDLE(See figure 2)
„ Insert the lower handle (6) into the housing hole.
„ Using the supplied screws (10), fasten the
lower handle to the housing using a star-head
screwdriver (not supplied).
INSTALLING THE UPPER HANDLE(See figure 2)
„ Position the upper handle so the holes line up with
the lower handle holes.
„ Insert the supplied hex bolt (11) through the hole
from the outside of the handlebar.
„ Thread the knob (4) onto the hex bolt (11) to
tighten securely into place.
INSTALLING THE GRASSBOX (See figure 3)
„ Lift the rear discharge door.
„ Lift the grassbox by its handle and place under the
rear door, so that the hooks on the grassbox frame
are seated into the slots in the handle bracket.
„ Release the rear door. When installed correctly,
the hooks on the grassbox will rest securely in the
slots on the handle brackets.
OPERATION
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
English (Original instructions)
WARNING
WARNING
WARNING
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., Come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal inju-
ry. Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized service center.
BATTERY REMOVAL (See figure 4)
„ Release the bale lever to stop the product.
„ Open the battery door to access the battery
compartment.
„ Remove the battery key.
„ Press in and hold the battery release button with
firm grip.
„ Remove battery pack from the product.
BATTERY INSTALLATION(See figure 4)
„ Lift and hold up the battery door.
„ Align the battery with the dethatcher's battery port.
„ Make sure the battery release button snaps in
place and that battery is fully seated and secure in
the dethatcher before beginning operation.
„ Insert the battery key.
„ If the machine is not going to be used immediately,
do not insert the battery key.
„ Close the door.
STARTING THE DETHATCHER
„ Press and hold the safety lock-out button. This
makes the bale switch operational.
„ Press the bale switch against to the handlebar to
operate.
STOPPING THE DETHATCHER
„ Release the bale.
MAINTENANCE
The dethatcher cylinder can cause injuries! Prior
to making adjustments, unplug unit and wait until
the dethatcher cylinder has stopped. Wear heavy-
duty work gloves when making adjustments. If the
dethatcher cylinder is not yet worn but individual
springs have broken, these must be replaced. Only
identical replacement springs may be used.
3
WARNING