Herunterladen Inhalt Inhalt Diese Seite drucken

Fan Time Lag; After Run Time - Atag HIDD8471E Gebrauchs- Und Montageanweisung

Induktions-kochfeld mit integrierter absaugung
Vorschau ausblenden Andere Handbücher für HIDD8471E:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operation

4.25.2 Fan time lag

The fan time lag is used after cooker in order to remove
cooking odours. The fi lter is also dried in the fan.
Setting the fan time lag
1. Select the fan indication.
2. Then use the Plus key
to set the required time for the fan time lag.
Left position:
Centre position:
Right position:
3. After a few seconds your input will be assumed and the
procedure will have commenced.
The timer symbol
4. The fan will be switched off when the time has lapsed.
If a cooking zone is switched on, the timer does not run
until the cooking zone has been switched off . If the hob is
switched off using the On/Off key during fan after run-time,
the timer runs down to a low fan level.

4.25.3 After run time

The fan motor should continue operating for another
10 - 20 minutes every time the hob has been used for
cooking.
If the fan is in operation and no fan run-on is set, there is an
automatic run-on of 5 minutes at level 1 after switching off .
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air fi lter, please always allow for
a stop delay time of 10 - 60 minutes in order to optimally
remove cooking odours.
When the fan is switched on again, in rare cases the odour
molecules present in the fi lter may be combined with steam
so that they are detected again. These remaining odours will
disappear when the fan continues to operate.
NOTE
When the convection air mode is in operation, ventilation
must be suffi cient in order for the air humidity to be
removed.
Replacement of the fi lter
If an existing carbon fi lter must be cleaned or replaced, this
is indicated in the fan display by a
operation).
When the fan is switched on, the display for a cooking
process is deleted.
To reset the display, the fan display and the sensor fi eld must
be pressed simultaneously for approx. 3 seconds.
If no carbon fi lter is used, the display indication
be reset.
or the Minus key
hours
every 10 minutes
every minute
of the fan lights up.
(after 150 hours of
GB
of the timer
must also
45

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis