Philips AVENT SCD501 Benutzerhandbuch Seite 7

• When the parent unit and baby unit are
linked, the 'link' light turns solid green.
• If no connection is established, the 'link' light
continues to flash red and the parent unit
beeps.
What to do if no link is established
•
If the parent unit is out of range, place
it closer to the baby unit.
•
If the baby unit or parent unit is too
close to another DECT appliance
(e.g. a cordless phone), switch off this
appliance or move the unit away from
this appliance.
•
If the baby unit is switched off, switch
it on.
5.2.1 Operating range
• The operating range is up to 300 metres/985
feet outdoors and up to 50 metres/150 feet
indoors.
•
The operating range of the baby monitor
varies depending on the surroundings and
factors that cause signal attenuation. Wet
and moist materials cause so much signal
attenuation that the range loss is up to 100%.
For signal attenuation from dry materials, see
table below.
Dry materials
Wood, plaster, cardboard,
glass (without metal,
wires or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium
sheets
6 Features
6.1 Smart Eco mode
This baby monitor has Smart Eco modes as a
standard feature. This mode is always active and
automatically reduces the DECT signal from the
baby unit to the parent unit to save energy and
reduce radio transmission.
6.2 Baby unit
6.2.1 Nightlight
The nightlight produces a soft glow that comforts
your baby.
Press the nightlight button on top of the baby
1
unit to switch the nightlight on or off.
Material Loss of
thickness range
< 30cm 0-10%
(12in)
< 30cm 5-35%
(12in)
< 30cm 30-100%
(12in)
< 1cm 90-100%
(0.4in)
< 1cm 100%
(0.4in)
7