Installation; Important Information; Fitted Units; Installation Dimensions - KKT KOLBE EBMS4503S Benutzerhandbuch

Installation

Installation

Important Information

!
• This appliance is NOT intended for use in a commercial
environment.
• The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
• In case a new socket is needed, installation and cable
connection must only be done by a qualified electrician.
If the plug is no longer accessible following installation,
a pole disconnecting device must be present on the
installation site with a contact gap of at least 3 mm.

Fitted units

• This appliance is only intended to be fully fitted in a
kitchen.
• This appliance is not designed to be used as a tabletop
appliance or inside a cupboard.
• The fitted cabinet must not have a back wall behind the
appliance.
• A gap of at least 45mm must be maintained between
the wall and the base or back panel of the unit above.
• The fitted cabinet must have a ventilation opening of

Installation dimensions

Note. There should be a gap above the oven.
• Adapters, multiway strips and extension cords must not
be used. Overloading can result in fire.
• If the appliance is not fitted with a supply cord and a
plug, the connection equipment must have a contact
separation in all poles that provide full disconnection,
and the appliance must be incorporated in the fixed
wiring in accordance with the wiring rules.
250 cm² on the front. To achieve this, cut back the base
panel or fit a ventilation grille.
• Ventilation slots and intakes must not be covered.
• The safe operation of this appliance can only be gua-
ranteed if it has been installed in accordance with these
installation instructions.
• The fitter is liable for any damage resulting from incor-
rect installation.
• The unit into which the appliance is fitted must be heat-
resistant up to 90°C.
51