KKT KOLBE EBMS4503S Benutzerhandbuch Seite 43

Using the appliance
Steam note:
• Before steam cooking:
Before starting the steam cooking mode, if the tank is
short of water, press button, abnormal buzzer will
ring and the screen icon will show water scarcity status
of water level to remind you to add water.
Note: Before starting the steam cooking mode, please
clean the water tank.
• During steam cooking:
During steam cooking mode, if the tank is short of water,
abnormal buzzer will ring and the screen icon will show
water scarcity status of water level to remind you to add
water. After adding water, it can work normally.
• After steam cooking:
After steam function is finished , the water in boiler will
be withdraw to water tank. This process lasts for about 1
minute.
During the process to withdraw the water back to water
tank , if the water tank is
full , the system will be beeping 10 times to remind you
clean up the tank. After the water tank is empty, the
system will continue to withdraw water.
Note: After steam cooking, please remove the water
from water tank.
Add water to here
Auto Scale Removal Function
For best cleaning results, we recommend that you use
detergent sodium citrate, which were randomly for des-
caling steam microwave oven. Follow the manufacturer's
instruction on the packaging. It is suggested that desca-
ling function should be used after the steam function has
been run for 20 hours.
• Power up the system, remove the water tank, inject
1000ml of fresh water into the water tank, adding a
pack of descaling agent.
• Push the water tank into the appropriate location of the
appliance.
• In standby mode, press
lights, screen displays default mode d01, default weight
0.10, corresponding cooking time and „ Kg „"Min" light up.
• Press repeatedly, when „ CLE „ indicator lighten, it
means to enter Scale emoval function. "Min" and default
time „ 20:00 „ lighten, tank icon show the current water
level ( Water, lack of water, full of water ), other icons
disappear.
• Press to start the program.
• Stay whole 1 minute after the program has finished,
take out the water tank and pour the water in the tank.
Thoroughly clean the water tank.
• Replace the fresh water, repeat steps 3 to 6.
Note: The descaling process shal not be shut down. If the
descaling process is shut down before the end, the entire
program must be started from step 3.
Defect codes
Below defect codes may occur during steam functions:
E-06: 1-Water tank is not close well.
E-05: water system abnormal, need to contact for Engi-
neer to check, below is the possibilities:
• The water sensor is abnormal.
• The water pipe is abnormal.
• The water pump is abnormal.
• The water tank is abnormal.
button, the display
45