Sun SWB 200 Betriebsanleitung Seite 76

76
Downloaded from www.Manualslib.com
5-39
5-40
5-41
5-42
5-43
manuals search engine
Operation
Fig. 5-39 OPTIMISATION "OP.4"
(fi rst measuring run of tyre/rim assembly)
Clamp the wheel on the balancer.
—
Readjust the wheel such that the valve is exactly
—
perpendicular to and above the main shaft.
Enter the valve position by pressing menu key F1.
—
The OPTIMISATION "OP.5" screen (Fig. 5-40) is displayed.
Fig. 5-40 OPTIMISATION "OP.5"
START is signalled on the screen.
Press the START key.
—
A measuring run is performed.
The OPTIMISATION "OP.6" screen (Fig. 5-41) is displayed.
5.10.5 Continue minimisation and
optimisation
Fig. 5-41 OPTIMISATION "OP.6"
(second measuring run of tyre/rim assembly)
From this screen weight minimisation is carried out in the
same way as optimisation.
Rotate the wheel into marking position following the
—
arrows.
Provide a single mark on the tyre outer side exactly
—
perpendicular to and above the main shaft.
Confi rm by pressing menu key F1
—
The OPTIMISATION "OP.7" screen (Fig. 5-43) is displayed.
Reading H 1
If H 1 (Fig. 5-42) is read out further optimisation is not
recommended. In this case the measured data does not
exceed the limit for recommendation of the optimisation
program. However, it is possible to continue optimisation so
as to improve wheel running conditions even below the limit
value (critical vehicle).
To continue optimisation:
Continue as shown on screen OPTIMISATION "OP.7"
—
(Fig. 5-43).
To abort optimisation:
Press the STOP key to return to the balancing program
—
and balance the wheel according to the readings.