Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Signal Monitoring
For weak signal or channel with CTCSS/DCS, long press monitor key [MONI] to monitor signal.
Torch Light Function
Press [MONI] key to enter torch light mode, press [MONI] again to enter torch light SOS
blinking mode, press [MONI] key again to shut down torch light function.
Keypad Lock Function
Press [ * ] key for 2 seconds to lock keyboard in unlock state;
Press [ * ] key for 2 seconds to unlock keyboard in lock state.
FM Radio Function
• Long press [MENU] key for 2 seconds to enter FM radio status, first line shows FM, second
line shows current frequency; Long press [MENU] key again for 2 seconds to exit FM radio
status
• When in FM Radio status, Press [
] key to upward seek radio station, then press [#] to
automatically upward seek, and stop at station with signal; Press [
] key to downward seek
radio station, then press [#] to automatically downward seek, and stop at station with signal.
Also we can key in radio frequency directly by numeric keypad.
• When in FM Radio status, press [ ] key to save current frequency to specify channel, press
[
] or [
] key to select channel to be saved, then press [MENU] to confirm save; Press [
]
key to delete current frequency, press [
] or [
] key to select channel to be deleted, then
press [MENU] to confirm delete; Press [EXIT] to conduct frequency/channel switch.
• When in FM Radio status, will automatically return to transceiver status when in transmitting
or long press [MONI] key, then automatically return to FM radio status after signal disappears
for 10 seconds. Also we can set whether monitor transceiver signal in FM radio status by
menu No.22 "FMDW", if on, then will automatically back to transceiver status when signal
detected, then automatically return to FM radio status after signal disappears for 10 seconds.
Fall Alarm Function
Open fell alarm function by Menu No.20 " FALL" setting, will automatically check transceiver
direction. If transceiver inclines and level angel is less than 40 degree for 10 seconds,
equipment will be in alarm status and issue alarm voice. And stop alarm when back to vertical
stand for 2 seconds.
Main Function Operation
Modes Selection
There are three kinds of display modes that can be chosen: Frequency, Channel and frequency
channel modes, can be switched by pressing [EXIT] key.
※Note：By co-operation of Main/Auxiliary Switch Key[
] and Mode Switch Key [EXIT] to
have different modes coexist. LCD Screen"
"Points to main frequency or channel, another is
auxiliary frequency.
11
Werbung
Inhaltsverzeichnis
Fehlerbehebung
