Makita UC3041A Bedienungsanleitung Seite 6

･
･
･
･
･
Intended use
The tool is intended for cutting lumbers and logs.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.29 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB (A)
Downloaded from www.Manualslib.com
Chain oil
Chain brake released
Chain brake applied
Prohibited!
Only for EU countries
Do not dispose of electric equipment
together with household
material!
In observance of the
Directive, on Waste Electric
Electronic Equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
A-weighted noise level
) : 90.3 dB (A)
pA
) : 101.3 dB (A)
WA
Wear ear protection
manuals search engine
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
waste method and may be used for comparing one tool
with another.
European The declared vibration emission value may also be
•
and used in a preliminary assessment of exposure.
and its
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
compatible used.
Be sure to identify safety measures to protect the
•
ENE085-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENF002-2
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
ENF100-1
Designation of Machine:
Chain Saw
Model No./ Type: UC3041A, UC3541A, UC4041A
Specifications: see "SPECIFICATIONS" table.
Conforms to the following European Directives:
2000/14/EC, 2006/42/EC
They are manufactured in accordance with the following
Standard or standardized documents:
EN60745
The Technical file in accordance with 2006/42/EC is
available from:
ENG905-1
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
determined
The conformity assessment procedure required by
Directive 2000/14/EC was in Accordance with annex V
Measured Sound Power Level: 102.2 dB (A)
Guaranteed Sound Power Level: 104 dB (A)
000331
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
6
total value (tri-axial vector
2
) : 4.7 m/s
h
2
26.4.2013
Yasushi Fukaya
Director
ENG900-1
sum)
ENG901-1
ENH021-8