Remove The Dustbag; Fitting A Dustbag; Replacing The Motor Protection Filter; Insert The Hose Connector Into The - Miele SG-Serie Gebrauchsanweisung

However, if the cleaner has been used
to vacuum up fine dust, such as plaster,
brick dust, cement or flour, the pores of
the dustbag will become blocked very
quickly.
This affects the air permeability of the
bag, and the marker will indicate that
the bag is "full" even when it is not. The
dustbag must be replaced if this is the
case.
If, on the other hand, a large amount of
hair and carpet fluff which typically con-
tains a lot of air is vacuumed up, the in-
dicator may fail to react even though
the bag is full. You should still change it.
Both these extremes can occur.
Remove the dustbag (Fig. 35)
 Press the release catches at the side
of the hose connector, and lift the
hose from the socket (Fig. 02).
 Lift the release catch for the dust
compartment lid and raise the lid as
far as it will go (Fig. 09).
The dustbag has a flap which closes
automatically when the dust compart-
ment lid is raised to prevent any dust
escaping.
 Pull the dustbag out by the grip on
the collar.
Fitting a dustbag (Fig. 36)
 Fit the new dustbag into the holder as
far as it will go. Leave the dustbag
folded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
A safety device prevents the lid clos-
ing without a dustbag in place.
Do not force it.

 Insert the hose connector into the

suction opening on the vacuum

cleaner until it clicks into position. To

do this, line up the guides on the two

pieces (Fig. 01).

Replacing the motor protection filter

(Fig. 37)
Replace the motor protection filter
whenever you start a new packet of
dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain 4 motor protection fil-
ters.
 Open the dust compartment lid (Fig.
09).
 Pull the dustbag out by the grip on
the collar (Fig. 35).
 Lift up the filter frame until it clicks
and remove the old motor protection
filter. Hold the filter by the clean, un-
soiled section to remove it (Fig. 37).
 Replace with a new motor protection
filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go (Fig. 36).
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
en
53