Kenwood KDC-BT950DAB Bedienungsanleitung Seite 30

Bluetooth®
(for
Bluetooth mode settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
[BT MODE]
[PHONE SELECT]
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
" " appears in front of the current playback audio device.
[AUDIO SELECT]
• You can connect a maximum of two Bluetooth phones and one
Bluetooth audio device at a time.
[DEVICE DELETE] 1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
[PIN CODE EDIT] Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
[RECONNECT] [ON]: The unit is automatically reconnect when the last connected
Bluetooth device is within the connectable range. ; [OFF]: Cancels.
[AUTO PAIRING] For
[ON]: The unit is automatically paired with the supported Bluetooth device
(iPhone/iPod touch) when it is connected through USB input terminal.
Depending on the operating system of the connected device, this function
may not work. ; [OFF]: Cancels.
22
ENGLISH
/ /
.
Default: [XX]
:
)
[INITIALIZE] [YES]: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; [NO]: Cancels.
Bluetooth test mode
You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1 Press and hold .
"PLEASE PAIR YOUR PHONE PIN 0000" appears on the display.
2
Search and select the name of your receiver ("KDC-BT950DAB"/
"KDC-BT450DAB"/ "KMM-BT407DAB") on the Bluetooth device.
3
Operate the Bluetooth device to confirm pairing.
"TESTING" flashes on the display.
The connectivity result (OK or NG) appears after the test.
PAIRING: Pairing status
HF CNT: Hands-Free Profile (HFP) compatibility
AUD CNT: Advanced Audio Distribution Profile (A2DP) compatibility
PB DL: Phonebook Access profile (PBAP) compatibility
To cancel test mode, press and hold B SRC to turn off the unit.