Trimming The Quadrocopter; Troubleshooting - Carrera RC Race Copter Montage- Und Betriebsanleitung

Auto-Start & Fly to 1 m
16 Press the 'Auto-start & fly to 1 m' button on
the controller, in order to start the motors
and automatically fly up to the altitude of
about 1 m. You are able to influence the di-
rection of flight at any time during the start-
ing operation by means of moving the right
joystick. The Quadrocopter will maintain
itself in position automatically as soon as
the altitude of about 1 m has been reached.

Trimming the Quadrocopter

17 Auto-trimming
1. Place the Quadrocopter on a hori-
zontal surface.
2. Link the Quadrocopter with the con-
troller as described in "Linking the
model with the controller".
3. Slide the gas lever and the lever for
forward / back simultaneously into the
right lower corner. The LED on the Quad-
rocopter flashes on briefly and then
lights up continuously. The signalling
tone will sound once.
4. The neutral setting is completed.
18 When hovering, if the Quadrocopter flies to
the left or right without you moving the lever
for left / right movement, please proceed as
follows: If the Quadrocopter moves on its
own fast or slow sideways to the left, press
the lower right trimmer for right / left tilt in
steps to the right. If the Quadrocopter
moves right, press the trimmer for right /
left tilt in steps to the left.
19 When hovering, if the Quadrocopter flies
forwards or backwards without you mov-
ing the lever for forwards or backwards
movement, please proceed as follows:
If the Quadrocopter moves on its own fast
or slow forwards, press the upper right
trimmer for forwards / backwards in steps
downwards. If the Quadrocopter moves
backwards, press the trimmer for forwards /
backwards in steps upwards.
Downloaded from www.Manualslib.com
ENGLISH
manuals search engine
When hovering and without you moving the
20
lever for circling on the spot, if the quadro-
copter rotates to left or right, proceed as
follows: If the quadrocopter rotates quickly
or slowly to the left around its own axis,
press the trimmer for rotation below left in
steps to the right. If the quadrocopter ro-
tates to the right, press the trimmer for rota-
tion in steps to the left.
Changing the rotor blades
21 Use a scredriver for unscrewing a rotor
blade. Make sure that you draw the rotor
blade with great care vertically upwards,
and hold the motor from below to stabilise
it. Screw the rotor blade firmly back on to
the quadrocopter.
QR code for motor-change system,
22
spare parts and further information.
23 WARNING!
Be sure to note the marking and colour,
also the tilt angle of the rotor blades!
Front left: red – marking "A"
Front right: red – marking "B"
Rear right: black – marking "B"
Rear left: black – marking "A"
Rotor protection cage
24
The Rotor protection cage is removable.
Do this by removing one screw underneath
each rotor blade.
TIP: only remove the Rotor protection
cage once you have made 10-20 flights
and feel safe enough not to need it!

Troubleshooting

Problem: Remote control does not work.
Cause: The ON/OFF-power switch is
turned "OFF".
Solution: Turn the ON/OFF-power switch "ON".
Cause: The batteries have been wrongly
inserted.
Solution: Check if the batteries have been
correctly inserted.
22