Changing The Filters In Cleanspace2 - PAFtec CleanSpace2 Handbuch

English

5. Changing the Filters in CleanSpace2

CHANGING THE PRE-FILTER
We recommend changing the pre-filter daily. Prior to opening the filter cover and removing the pre-filter, clean the
outside of the Respirator with CleanSpace
the inside of the Power Unit. To unlock the filter cover lift the pin located on the end of the filter cover.
The filter cover should easily swing open exposing the used CleanSpace2
replace with a new pre-filter, taking care not to disturb the particulate filter. Swing the filter cover back into its closed
position and press the pin down until clicked back into place.
CHANGING THE PARTICULATE FILTER
The particulate filter should be changed when the CleanSpace2
filter is blocked. To unlock the filter cover lift the pin located on the end of the filter cover. The filter cover should
easily swing open exposing the used CleanSpace
replace with a new CleanSpace
press the pin down until clicked back into place.
Only CleanSpace
The CleanSpace
method to clean the CleanSpace filters. Cleaning the filters affects the filtering efficiency and reduces the protection
factor.
The markings on these filters in relation to EN12942 must not be confused with markings on filters related to any
other standard.
Downloaded from www.Manualslib.com
DO NOT FORCE THE FILTER COVER OPEN BEYOND 90
™
Cleaning Wipes or a damp cloth to prevent potential contamination of
™
particulate filter and pre-filter. Swing the filter cover back into closed position and
™
filters and pre-filters should be used with the CleanSpace2
IT IS ESSENTIAL THAT THE CORRECT FILTER TYPE IS SELECTED
FOR THE CHOSEN APPLICATION.
™
filters are NOT reusable and should NOT be cleaned. Do not use compressed air or any other
manuals search engine
™
Before using CleanSpace2
you are using the correct filter type for the environment you
are working in. The CleanSpace2
with a particulate filter.
Before changing the filter on the Respirator, move out of
the contaminated area and remove the Respirator. Used
filters should be disposed of responsibly and treated as
non-recyclable hazardous* waste (* dependent on the
contaminant being filtered). Filters need to be regularly
changed. The frequency of change depends on use and
concentration of contaminants in the atmosphere.
™
pre-filter. Remove the used pre-filter and
™
filter alarm alerts the wearer that the particulate
™
filter. Remove the used filter (and pre-filter, if applicable) and
8 8
™
you should ensure that
™
Power Unit is supplied
O
™
Respirator.