Data Sheet - PAFtec CleanSpace2 Handbuch

7. Cleaning CleanSpace2™ (continued)
To clean the exhalation valve, gently wash the warm water solution through the valve and use a sponge
•
to gently clean the valve surface
Rinse the mask and valve well in warm running water. IMPORTANT: If the mask is not rinsed thoroughly,
•
residue from cleaning solution may irritate the wearer's skin or cause the valve to stick. Replace the
valve cap before use.
3. Dishwasher
The mask can be cleaned in a standard dishwasher on the top shelf, face up to prevent water pooling in the mask.
Remove the valve cap (using the instructions above). Use dishwasher detergent on a normal cycle.
Drying the mask
After cleaning, allow the mask to air dry in a clean environment, face up to prevent water pooling. Note: Do not dry
the mask by exposing directly to heat i.e. hair dryers or heaters. The mask can also be hand-dried with a clean, lint-
free cloth. IMPORTANT: Cleaning can cause the exhalation valve leaf to stick. Before use, check that the exhalation
valve leaf operates freely by gently lifting the valve. Replace the valve cap before use.
Cleaning the Power Unit
WARNING: The Power Unit contains a battery, electronic parts and a motor. The Power Unit should NEVER be
submerged in water or washed in running water. To clean the Power Unit, follow the instructions below:
After removing the mask, remove the neck pad. Leave the filter in place to prevent any dust or liquids
•
from getting into the Power Unit.
Use a gentle brush to remove any dirt, grit or fibres from the Velcro attached to the Power Unit.
•
Using CleanSpace2
•
cleaned with a damp cloth.
Allow the Power Unit to air dry in a clean environment. The Power Unit can also be hand-dried with a
•
clean lint-free cloth. Note: Do not dry the Power Unit by exposing directly to heat (i.e. hair dryers or
heaters) or compressed air.
Cleaning the harness and neck pads
The harness and neck pads can be washed in warm soapy water or machine washed. After cleaning, allow the
harness and neck pads to air dry in a clean environment.
Note: Do not dry the harness or neck pads by exposing directly to heat i.e. hair dryers or heaters. For information on
trouble shooting and faqs please go to the www.paftec.com website.

8. Data Sheet

Description
The CleanSpace2
provide comfortable respiratory protection at work and at home.
Applications
Welding, Woodworking, Manufacturing, Smelting, Construction, Recycling Plants, Emergency Services, Mining,
Agriculture, Processing Plants, Grinding, DIY, etc.
Key Features
Lightweight and comfortable
•
Intelligent breath responsive protection
•
Improved mobility and compatibility with other PPE
•
High quality and reliability
•
Endurance Pack to extend operating time
•
Hygienic and soft face piece
•
Battery and filter warnings to support continuous protection
•
Downloaded from www.Manualslib.com
™
Cleaning Wipes, wipe down the outside of the casing. The Power Unit can also be
™
Respirator is an innovative, breath responsive, powered air purifying respirator, designed to
manuals search engine
Approvals
AS/NZS1716:2012 PAPR-P2
EN 12942:1998+A2:2008 TM3
ISO9001
11 11
English