Installation; Location; Electrical Connection - Electrolux EUF 27391 W5 Benutzerinformation

46 electrolux

INSTALLATION

Location

The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely
around the back of the cabinet. To
ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the
cabinet and the wall unit must be at
least 100 mm . Ideally, however, the
appliance should not be positioned
below overhanging wall units. Accurate
levelling is ensured by one or more
adjustable feet at the base of the
cabinet.
NP00
Attention
It must be possible to disconnect the
appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Downloaded from www.Manualslib.com manuals search engine

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must
be used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to
a separate earth in compliance with
current regulations, consulting a
specialist technician.
The M M anufacturer d d eclines a a ll
responsibility i i f t t he a a bove s s afety
precautions a a re n n ot o o bserved.
This appliance complies with
the following E.E.C. Directives:
• 87/308 E E EC of 2/6/87 relative to
radio interference suppression.
• 73/23 E E EC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
• 89/336 E E EC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.