File - Menu - Honeywell ESSER essernet SEI1 Bedienungs- Und Installationsanleitung

®
Serial essernet
-Interface  Supervisor Gateway – only
®
Serial essernet
In accordance to the requirements for Austria the serial may be used as a central dispatching
system. Observe the following settings for this application.
•
Enable programming mode (S2/1 ON) and configure SEI1 settings with the programming
tool >SEI-Setup<.
•
For normal operation of the SEI1, set the DIP switch (S2/2 OFF) because operation is not
permitted with DIP switch (S2/2 ON – factory setting).
12.1

File - menu

Fig. 19: File - menu
New Creates a new customer data file for the SEI1 FACP 800x /
IQ8Control - Remote (Part No. 784859).
Open Opens a selection of previously saved customer data files.
Save Saves the open file using the current file name.
Save as.. Saves the open file using a freely selectable file name
Datatransfer
Data transmission between the PC interface and the serial essernet
Recent file Display/opens the most recent file
Exit Quits the program without saving
64
interface (SEI1)
A
FB 798819 / 05.18

interface