Honeywell ESSER essernet SEI1 Bedienungs- Und Installationsanleitung Seite 53

Fuse T 1 A / 250 V
F1
S2 - Mode DIP switch – for setting the programming mode of the SEI1 Type
System 8000 / IQ8Control-Remote FACP (Part No. 784859)
Normal operating mode for all other versions (factory setting)
S3 - Reset RESET button, changed parameters will be activated.
J1
Programme
Jumper  EMC protection for essernet
J3,J4,J5,J6
LED  Interface function display
SI 01 / SI 02
LED red
LED yellow
SI 01  RS485 interface, internal
SI 02  Interface module RS232/V.24 or TTY/CL 20 mA
V 11,12,13 LED indicators (red, yellow, green), see Chapter 10.1
X2 Connector operating voltage
X5 Alternative slot for essernet
installation in the FACP or extension housing
X7 Connector essernet
X12 Connection service PC. Only required with SEI1 (Part No. 784859)
X13 Protective earth (PE) connector
X14 Slot for essernet
in the housing (Part No. 788606)
•
Use clearly identified cable I-Y (St) Y n x 2 x 0,8 mm or comparable and
employ only shielded twisted pair cables with special designation for fire
detection, and consider furthermore the requirements of the local standard!
•
The shielding must be connected for EMI protection of the cable!
•
All voltage and signal lines must be secured to prevent slipping by using a
suitable attachment materials such as plastic cable binders.
•
Take care to ensure that no cables are pinched or damaged.
FB 798819 / 05.18
Never repair or bridge the device fuses that are installed or
replace them with anything other than the stated type.
open: EEPROM write protection active
(factory setting)
closed: EEPROM write protection de-activated
(required only for programming)
: failure
: data / communication
®
®
®
module (Part No. 784840.10 / 784841.10) during installation
Serial essernet
®
module (Part No. 784840.10 / 784841.10) during
®
interface (SEI1)
53