Honeywell ESSER essernet SEI1 Bedienungs- Und Installationsanleitung Seite 45

Note on the essernet
In sub net, e.g. a serial essernet
No. 1+2 should be configured. The essernet
increase. All other configurations are impossible.
The essernet address for the SEI1 in the main network is freely selectable, but it is meaningful
to select the upper next free essernet
•
Operation from the sub net into the main network is not possible.
•
This application is not suited to build a remote operating panel for the main
network based on the FACP 8000 / IQ8Control-Remote unit.
•
Faults from the sub net are also displayed on the fire alarm control panels in
the main net.
Example display
Fault in sub net – FACP No. 01 with message 13
Display in the main network – fault on primary loop 0113 in the sub net.
FB 798819 / 05.18

address
®
interface (SEI1) and one FACP, only the essernet
®
address for this SEI1.
Serial essernet
®
address always starts with no. "1" with a further
®
interface (SEI1)
®
address
45