Technical Specifications; Maintenance - Matrix AUTOMOWTIC MOW 800 Bedienungsanleitung

UK
4. The mower crosses the fence line and contin-
ues outside the perimeter.
a) The fence line turn angle is too steep. The inner
angle must be at least 120°.
b) The fence line is too close to a slope. Adjust the
fence line position to be in accordance to the rec-
ommendations.
c) The fence line signal is weak. The fence line must
d) Check if there are any high-power appliance(such
as transformer, generator,telecommunications
tower, ect.) nearby. Those appliances could inter-
fere the machine signer.
5. The battery is not charging, or the mower
does not charge properly, it bumps the charge
station again and again.
tact with the paddles of the charging station.
Clean them. (Make sure to disconnect the power
before cleaning.)
hausted by itself. If the battery broken a little you
can re-charge many times to active the battery or
you can change the battery.
d) The sensor of the machines is damaged.
6. The mower does not return to the charging
station for charging.
a) The fence line is too long. The battery lever is
not enough to return the mower to the charging
station. Turn off the mower and carry it to the
station.
b) If the mower was stopped by obstacle it will stop
working
7. Subarea function is failure.
Every working area need to set working time.
8. The island can not work.
The island should be circle not square
9. The mower make a circle in the island and
never go to the working area.
The mower will go around 3 circles, or about 40 sec-
onds, then go to the working area.
36

TECHNICAL SPECIFICATIONS

Size:
Operating voltage:
Charging time:
Average operating time:
Cutting width:
Cutting height:
Mowing capacity for each recharge:
Protection class:
Insulation class:
Guaranteed sound power level L
Weight:
Input / Output:
The declared vibration total value has been
measured in accordance with a standard
test method and may be used for compar-
-
ing one tool with another that the declared vibra-
tion total value may also be used in a preliminary

MAINTENANCE

-
Make sure the mower is not in working state during
all work on the mower's chassis, such as cleaning or
replacing the blades.
Important information
Never use a high-pressure washer or even running
water to clean the robotic lawn mower. Never use
solvents for cleaning.
Inspect the robotic lawn mower each week and
replace any damaged or worn parts. The following
must be carried out in the weekly inspections:
• Clean the charging station from grass, leaves, twigs
and other objects that may impede the robotic lawn
mower from docking with the charging station.
• Make sure the mower is not working and put on
a pair of protective gloves. Turn the robotic lawn
mower upside down. Check the following:
a) Clean the drive wheels. Grass in the drive wheels
can impact on how the lawn mower works on
slopes.
b) Clean the front wheels. Grass on the front wheels
c) Clean the body, chassis and cutting system. Grass,
leaves and other objects that weigh down the
product affect performance.
d) Check that all mower blades are intact. Check
also that the blades can pivot freely. Even if the
mower blades are intact, they must be replaced
2
IP X4
III
: 72 dB (A)
WA
8.4 Kg