Troubleshooting - Matrix AUTOMOWTIC MOW 800 Bedienungsanleitung

Work Mode
Work Hours
Work Days
Reset Timer
• Enter "Work hours" page, set start time, working
time for each area separately, press OK to confirm.
And then press to return to the homepage.
Start Time: 00:00
• Keep the mower stay where it is, don't turn off, and
don't press START button, otherwise the subarea
setting is invalid. The mower will start to work as
per setting time and area.
• After Area 1,2,3 Setting is done, there will be a sym-
bol show on the screen:
no more than 250 minutes.

TROUBLESHOOTING

NOTE: For any fault of the machine, please always
check the charging station first, to see if it is under
proper working status(fence line is not loosen, or
bite by your pets, or cut by the blades of the ma-
chine, or your AC power shutted down when the
machine is working). The lamp on the charging sta-
tion will be red flashing if there's such problem.
1. The mower does not start.
a) The mower starts in an ineffective fence line area.
Check the fence line for repair.
b) Check the emergency stop switch. If the emer-
gency stop switch is locked, press the emergency
stop switch then press red power switch.
c) If the mower has not been used for a long while,
the battery may be empty. Make sure to charge
it again after charging. Even when unused, it is
recommended that the battery is charged every
3 months.
2. The mower does not move forward.
a) The bumper sensor may be damaged.
b) If the grass is very long at the first time, which will
shelter the sensor tube, please mow the grass
with a traditional lawn mower before using the
robot mower.
3. The mower does not mow properly or at all.
a) Turn off the mower. Check if the blades are prop-
erly installed. Replace the blades if damaged.
b) If the mower is in a slope which has an angle more
than 28°, the mower will automatically stop.
c) The root part of the blade holder is stuck by ob-
jects or grass. Remove them and restart.
d) The grass is too dense to be mowed due to the
automatic protection of machine.
e) The machine stopped automatically to protect
the PCBs and other compnents when it tested the
motor temperature is too high.
UK
35