Hilti PM 2-PE Original Bedienungsanleitung Seite 18

▶ Do not allow the batteries to overheat and do not expose them to fire. The batteries may explode or
release toxic substances.
▶ Do not charge the batteries.
▶ Do not solder the batteries into the tool.
▶ Do not discharge the batteries by short-circuiting, because this can result in them overheating and
causing blistering.
▶ Do not attempt to open the batteries and do not subject them to excessive mechanical stress.
▶ Do not use damaged batteries.
▶ Do not mix old and new batteries. Do not mix batteries of different makes or types.
2.6 Liquids
Under abusive conditions, liquid may leak from the battery. Avoid contact with this liquid. If contact
accidentally occurs, rinse with water. In the event of the liquid coming into contact with the eyes, rinse the
eyes with plenty of water and consult a doctor. Liquid leaking from the battery may cause irritation or burns.
3 Description
3.1 Product overview
3.2 Intended use
The PM 2-PE is a self-leveling point laser which allows a single person to carry out vertical alignment work
quickly and accurately. The tool features two coincident laser beams (beams that originate from the same
point). All beams have the same range of 30 m (range depends on the brightness of ambient light). The tool
is designed to be used to mark plumb points, mainly in interiors. When used for outdoor applications, care
must be taken to ensure that the general conditions are similar to those encountered indoors.
Possible applications are: Transferring points marked on the floor to the ceiling.
Modification of the tool is not permitted.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid risk of injury, use only genuine Hilti accessories and accessory tools.
The power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel
or when used not as directed.
3.3 Features
The PM 2-PE is self-leveling in all directions within approx 4°. Self-leveling takes only approximately 3
seconds.
When the self-leveling range is exceeded, the laser beam flashes to warn the user.
12 English
1
On/off switch combined with pendulum lock-
@
ing mechanism
LED
;
Laser exit window
=
Battery compartment
%
2288653
*2288653*