Fuse; Mounting Bracket; Screw Set; X 16 Mm Self-Tapping Screw - Kenwood TK-7360E Bedienungsanleitung

■ Installing the Transceiver
For passenger safety, install the transceiver securely using the supplied mounting bracket and
screw set, so the transceiver will not break loose in the event of a collision.
Note: Before installing the transceiver, check how far the mounting screws will extend below
the surface. When drilling mounting holes, be careful not to damage vehicle wiring or parts.
1 Mark the position of the holes in the dash, using the mounting bracket as a template. Using a
4.2 mm (5/32 inch) drill bit, drill the holes, then attach the mounting bracket using the supplied
screws.
• Mount the transceiver within easy reach of the user and where there is suffi cient
space at the rear of the transceiver for cable connections.
2 Connect the antenna and the supplied power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using the supplied hex-headed
screws.
4 Mount the optional microphone hanger in a location where it will be within easy reach of the
user.
• The microphone and microphone cable should be mounted in a place where they
will not interfere with the safe operation of the vehicle.
When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same
value. Never replace a fuse with one that is rated with a higher value.
M4 x 6 mm
Hex-headed screw
Antenna
connector
Power input
connector
DC power cable
2
Spring
Flat
washer
washer
Self-tapping screw
Black (–) cable
Red (+) cable
5 x 16 mm

Fuse

Optional
Microphone

Mounting bracket

12 V vehicle
battery