Sending An Emergency Alarm; Hot Microphone Feature - Motorola MTM800 Bedienungsanleitung

found at the left side of the MTM800 Enhanced.
The required time you need to press the Emergency button is set to
default to 0.5 seconds. The time can be configured by your Service
Provider.
To exit Emergency Mode, press and hold Exit. Your terminal will
switch to the Home display.

Sending an Emergency Alarm

Your MTM800 Enhanced will send an Emergency Alarm to the
dispatcher (if configured by your Service Provider):
• Automatically, upon entering Emergency Mode.
• If you press the Emergency button again while the MTM800
Enhanced is in Emergency Mode.
After sending the alarm, the display will show one of the following
delivery reports:
• Alarm Sent
• Alarm Failed
In both cases, the display returns within a few seconds to the main
screen of the Emergency Mode.
Due to no delivery confirmation in DMO, Alarm Sent information
confirms only sending the alarm.
The Emergency Alarm is a special status message sent to the
dispatcher monitoring the selected group. This can be used in dispatch
systems to highlight emergency calls.
Some systems do not support the Emergency Alarm feature when the
user is in a "Local Area Service" area.
Warning:
! !
Pressing the Emergency button, even if Transmit Inhibit is activated,
causes the MTM800 Enhanced to transmit immediately. The MTM800
Enhanced must NOT be within the RF sensitive area when entering
Emergency Mode.

Hot Microphone Feature

If the Hot Microphone feature was programmed into your MTM800
Enhanced by your Service Provider, you can make an Emergency
Group Call and talk to the dispatcher (and members of your group)
without the need to press and hold the PTT.
The microphone will stay open for a time period (programmed by
29