Sanus VLF311-B2 Montageanleitung Seite 10

2-3 Drill pilot holes and attach wall plate
CAUTION:
Avoid potential injuries or property damage! Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
Improper use could reduce the holding power of the lag bolt.
 DO NOT over-tighten the lag bolts [03].
 Tighten the lag bolts [03] only until the washers [04] are pulled firmly against the wall plate [01].
5.5 mm
(7/32 in.)
10
75 mm
(3 in.)
13 mm
(1/2 in.)
[04]
[03]