Machine With External Water Softener; End Of Service; Chap 5; Cleaning And Hygiene - Elettrobar River 262 Bedienungsanleitung

INSTRUCTION MANUAL FOR DISHWASHERS
GB
In machines equipped with an external water softener, after a certain number of cycles, the display will
show the message 'SOFT. MAINT.'. This indicates that the resins of the external softener must be
regenerated.
This signal remains even when the machine is off. To eliminate it, press and hold, for at least five
seconds, with the machine off and the door open, the START key (3).
•
At the end of the day always drain the machine as described in the "Machine draining" section.
•
Disconnect the power supply by means of the main switch and close the external water
cock.
•
Perform routine maintenance and clean the machine as described in the "Maintenance" section.
•
If possible, leave the door ajar to prevent the formation of unpleasant smells inside.
Before performing any maintenance, drain all water, disconnect the electrical
power supply, and close the external water cock.
To ensure machine hygiene, periodically perform the maintenance tasks listed below. Also carry out
a periodical sanitising treatment with suitable non-corrosive products available on the market.
Carry out this procedure at the end of the day when you see residual dirt on the filters:
1. Remove and clean the baskets.
2. Remove the tank as per the instructions in the paragraph on draining the machine.
3. Carefully clean the integral filter.
4. Thoroughly clean the tank and machine with non-abrasive disinfectant products.
5. Remove the standard filter by pulling it upwards as shown in Fig. 8 C and clean it carefully.
6. Do not use abrasive products or objects for cleaning the steel tank. Instead use a slightly soapy
damp cloth.
7. Do not use pressurised jets of water because they could damage the electric system.
8. When finished with the described tasks, carefully reposition each part.
The wash and rinse arms can easily be removed to allow periodic cleaning of the nozzles so as to
prevent possible clogging and/or deposits.
Proceed as follows ( Fig.10 ):
•
Unscrew ring nut R and release the arms.
•
Loosen the stops F and remove the semi-arms from the central body.
•
Wash all parts with running water. Clean the nozzles carefully, using a toothpick or small tools if
necessary.
•
Clean the arm rotation pins in the machine and the washing and rinsing water outlet area.
•
Put the arms back in place. Then check that they rotate freely.
Page 8 of 11

4.9.2 Machine with external water softener

Chap 5

5.1 Cleaning and hygiene

5.2 Maintenance of filtering group

5.3 Cleaning of wash arms

4.10 End of service

MAINTENANCE