Emptying The Machine; Machine Without Drain Pump; Machine With Drain Pump; Machines With Partial Draining: Self-Cleaning Cycle And Final Draining - Elettrobar RIVER 282 Bedienungsanleitung

If necessary, extract the tub filter and clean (
1. With the machine on (
2. Remove the integral filter (
3. Extract the overflow (
4. Press the START button (3).
5.
If necessary, extract the tub filter and clean (
If necessary, extract the tub filter and clean (
In machines equipped with an external water softener, after a certain number of cycles, the display will
show the message 'SOFT. MAINT.'. This indicates that the resins of the external softener must be
regenerated.
This signal remains even when the machine is off. To eliminate it, press and hold, for at least five
Downloaded from www.Manualslib.com
INSTRUCTION MANUAL FOR DISHWASHERS
Turn off the machine. Disconnect the electricity and shut off the water.
Remove the integral filter (
Extract the overflow by pulling upwards (
until you see the message 'DRAIN'.
Fig.7 B
The machine turns off at the end.
4.7.3

Machines with partial draining: self-cleaning cycle and final draining

Remove the basket from the machine.
Fig.4
With the machine on (
until you see the message 'DRAIN'.
Press the START button (3).
The machine will start a special wash sequence begins which makes it possible to clean and
drain the tub.
The machine turns off at the end.
manuals search engine
Fig.6 A
).
Fig.7 B
), and wait for the tub to drain completely.
Fig.7 C
).
Fig.4
), press the PROGRAMME SELECTION button (2)
Fig.6 A
).
), close the door.
Fig.7 C
).
), press the PROGRAMME SELECTION button (2)
Fig.7 C
).

4.8.1 Machine with external water softener

4.7 Emptying the machine

4.7.1

Machine without drain pump

4.7.2

Machine with drain pump

4.8 Resin regeneration

Page 7 of 10
GB