Chap 7 Advanced Settings - Elettrobar River 262 Bedienungsanleitung

INSTRUCTION MANUAL FOR DISHWASHERS
GB
The following adjustments should only be performed by a qualified technician.
1 2
To move from one command to the next, press the ON/OFF (1) button; to increase or decrease the parameters, press the CYCLE
SELECTION (2) and START (3) buttons. To exit the menu, press and hold the ON/OFF (1) button for a few seconds.
1 2
A LANGUAGE
B THERMO-STOP
C ENERGY SAVING
D PREHEATING
E DETERGENT PUMP
F RINSE AID PUMP
DOSAGE TIME
G
DURING WASHING
RINSE PRODUCT
H
DOSAGE TIME
I WATER HARDNESS
CYCLES FOR
REGENERATION
J ALARM WITH
EXTERNAL
SOFTENER
K CYCLE COUNTER
Page 10 of 11
O
PERATING TEMPERATURE
To access the temperature setting menu, press and hold the ON/OFF (1) button for a few seconds,
3
until the following menu appears:
A BOILER SET
B TANK SET
P
To access the settings menu, proceed as follows:
3
•
While the machine is switched off, open the door
•
Press and hold the CYCLE SELECTION (2) and START (3) buttons simultaneously for a few
seconds
•
To move from one command to the next, press the ON/OFF (1) button; to increase or decrease
the parameters, press buttons 2 and 3. To exit the menu, press and hold the ON/OFF (1)
button.
Changes the language in which user messages are displayed.
Enables or disables the Thermostop function.
Enables or disables the Energy saving function.
Enables or disables the Preheating function (fast machine heating).
Enables the detergent pump continuously. Press and hold button 3 to enable the detergent pump so
that its circuit can be loaded.
Enables the rinse aid pump continuously. Press and hold button 3 to enable the rinse pump so that its
circuit can be loaded.
Detergent pump operating time. Buttons 2 and 3 can be used to increase or decrease the dosage time.
Rinse aid pump operating time. Buttons 2 and 3 can be used to increase or decrease the dosage time.
(Machines with built-in softener only) Set the mains water hardness level in accordance with the table
below:
If an external softener is installed, it is possible to enter the number of cycles run before the machine
displays a request for maintenance. When the number of cycles has elapsed, the machine will display
the message "SOFTENER MAINTENANCE". To remove this alert, press and hold the START (3)
button while the door is open.
Indicates the number of cycles performed by the machine.

Chap 7 ADVANCED SETTINGS

Rinse temperature adjustment
Tank temperature adjustment
ARAMETERS
Measured
Water hardness
hardness
DF DH
0 ÷ 20 0 ÷ 11
21 ÷ 30 12 ÷ 16
31 ÷ 40 17 ÷ 22
41 ÷ 60 23 ÷ 33
no.
1
2
3
4