Cycle Selection And Start-Up; Automatic Cycle Start-Up (Optional); Turning Off The Machine; Removal Of Integral Filter - Elettrobar River 262 Bedienungsanleitung

INSTRUCTION MANUAL FOR DISHWASHERS
GB
•
Put mixed silverware into the special basket with the handles facing downwards.
•
Wash the dishes immediately after use, in order to prevent any residuals from hardening and sticking
on them.
•
Load the rack into the machine and close the door.
•
To avoid breakage, use only dishes that are intact and guaranteed for machine washing.
Do not place silver and stainless steel cutlery in the same basket, since this would cause the silver to
tarnish and the steel to corrode.
1
1 2
• The cycle ends with two short beeps. The START key (3) of the selected programme returns to
green and the display shows the message 'END'. The time bar flashes.
• A few seconds after start-up, it is possible to start the wash cycle in advance by pressing the START
key (3).
• In order to get rapid drying, immediately remove the rack from the machine at the end of the cycle.
This function makes it possible to start the cycle simply by closing the door without pressing any button.
To activate the function proceed as follows ( Fig.6 ):
•
With the machine off and the door open, press and hold, for at least five seconds, the key
START (3) until the letter A lights up on the time bar
•
To de-activate this function, with the door open, press and hold the START key (3) for five seconds.
• Press the button ON/OFF (1). The machine will shut off. On the DISPLAY (4), the middle segments
will stay on to show that the machine is powered up. Then, always disconnect the main power supply
up the line from the machine.
1. Turn off the machine.
2. Place the wash and rinse arms at a right angle to the edge of the door ( Fig.7 ).
3. Raise each semi-filter, grasping it by the handle.
Page 6 of 11
3

4.4 Cycle selection and start-up

• Based on the type of dishes and their conditions,
three types of cycles are available. ( Fig.4 ).
• Select the wash cycle that is suited for the
dishes to be washed. Repeatedly press the key
PROGRAMME SELECTION key (2) to show the
selected cycle on the display.
•
To start the programme, press the START
button (3) as shown alongside.
During the cycle, the key turns blue ( Fig.5 ) and
•
the time bar shows the progress of the cycle.
4.5 Automatic cycle start-up
.

4.6 Turning off the machine

4.7 Removal of integral filter

(Optional)