Emptying The Machine; Machine Without Drain Pump; Machine With Drain Pump; Machines With Partial Draining: Self-Cleaning Cycle And Final Draining - Elettrobar River 262 Bedienungsanleitung

INSTRUCTION MANUAL FOR DISHWASHERS
Turn off the machine. Disconnect the electricity and shut off the water.
Remove the integral filter ( Fig.7 A ).
Extract the overflow by pulling upwards ( Fig.8 B ), and wait for the tank to drain completely.
If necessary, extract the tank filter and clean ( Fig.8 C ).
1. With the machine on ( Fig.4 ), press the PROGRAMME SELECTION button (2)
until you see the message 'DRAIN'.
2. Remove the integral filter ( Fig.7 A ).
3. Extract the overflow ( Fig.8 B ), close the door.
4. Press the START button (3).
5. The machine turns off at the end.
If necessary, extract the tank filter and clean ( Fig.8 C ).
Remove the basket from the machine.
With the machine on ( Fig.4 ), press the PROGRAMME SELECTION button (2)
until you see the message 'DRAIN'.
Press the START button (3).
The machine will start a special wash sequence begins which makes it possible to clean and
drain the tank.
The machine turns off at the end.
If necessary, extract the tank filter and clean ( Fig.8 C ).
The message 'REGENERATION ON' in machines with built-in softeners indicates that the machine is
performing a resin regeneration cycle, and that the wash programme in progress could take longer than
usual.
N.B. Do not switch the machine off if a regeneration cycle is in progress.
In machines with a water softener, when the message 'NO SALT' appears, salt must be added to the
tank. Proceed as follows:
Remove the basket from the machine.
Remove the integral filter( Fig.7 ).
Unscrew the plug of the salt tank ( Fig.9 ).
Pour kitchen salt (about 700g) using the funnel provided.
Close the container again firmly.
To avoid corrosion problems, rinse the area around the salt tank plug manually, then run a
self-cleaning cycle.
The message 'NO SALT' will disappear after a few minutes.
4.8.3

Machines with partial draining: self-cleaning cycle and final draining

4.8 Emptying the machine

4.8.1

Machine without drain pump

4.8.2

Machine with drain pump

4.9 Resin regeneration

4.9.1 Machine with built-in water softener

GB
Page 7 of 11