Rinse Aid And Detergent; Chap 3 Risks And Important Warnings; Normal Service Conditions - Elettrobar River 262 Bedienungsanleitung

INSTRUCTION MANUAL FOR DISHWASHERS
GB
Max.
1 m
With discharge pump (available on
request)
•
Rinse aid is dispensed by the hydraulic measuring device installed standard on the
machine.
•
Dosing of detergent is manual, even if installation of an automatic measuring
device is always recommended.
•
Dosing is established based on water hardness by the installation technician, who
will also calibrate the measuring devices.
•
The level of liquids in the container must be high enough that it can be
drawn. It must never empty completely, or be topped off with corrosive or
impure products.
•
This appliance is to be used only for the use for which it was expressly designed. All other uses are to be considered unfit
and therefore dangerous.
•
The specialised personnel who will install the machine are obliged to appropriately instruct the user on the
appliance's operation and any safety measures that are to be complied with, also by providing practical
demonstrations.
•
Any type of service done on the machine, also in case of failure, must be performed only by the manufacturer or by an
authorised service centre and by qualified personnel, using only original spare parts.
•
Always disconnect or separate the machine from the electric and water networks before performing maintenance, repairs
or cleaning.
•
Untrained personnel must NOT use the machine.
•
The machine must NOT remain powered on when it is not in use.
•
NEVER open the machine door quickly if it has not finished the cycle.
•
NEVER use the machine without the factory-installed safety attachments
•
NEVER use the machine for washing object of a type, shape, size or material not guaranteed for machine washing or not
perfectly intact.
•
NEVER use the appliance or its parts as a ladder or support for people, things or animals.
•
NEVER overload the open door of front-loading machines, which are sized to support only the rack loaded with
kitchenware.
•
NEVER immerse bare hands in the washing solutions.
•
NEVER turn the machine over after installation.
•
If you notice a malfunction or leakage of liquids, immediately disconnect the electricity and shut off the water supply.
THE FOLLOWING IS ALSO IMPORTANT:
•
Never start a wash programme without the overflow in the tank.
•
Before you drain the tank, make sure you shut off the machine.
•
Never place magnetic objects near the machine, it may start even when the door is open.
•
Do not use the upper part of the machine as a support surface.
•
The machine may not be used by persons who are unauthorized or who have not been properly trained.
•
The installation technician is required to check for proper earthing.
•
When testing is complete, the installation technician must issue a written statement concerning correct installation and
testing in accordance with all standards and acceptable working practices.
Ambient Temperature : 40°Cmax /4°Cmin ( average 30°C)
Altitude
Relative humidity
Transport and Storage : between 10°C and 55°C with peack until 70°C ( max 24 hrs )
Page 4 of 11
•
If the drain is not at a lower level than the base of the machine, you can
use the version equipped with a discharge pump (available on request).
•
In this case the maximum drain height is 1 m.
•
Always check that the drain works properly and that it is not clogged.
•
All other solutions must be previously agreed upon and approved by
the manufacturer.

Chap 3 RISKS AND IMPORTANT WARNINGS

: until 2000 metrical
: max 30% at 40°C / max 90% at 20°C

2.6 Rinse aid and detergent

.

3.1 Normal service conditions