pewag erzberg Montageanleitung Seite 8

Mounting
Spread out the chain in front of or behind the tire and arrange
1
neatly (depending on the space, the chain may have to be
bunched together). Tension lever, tension spring and tension
chain must face outwards! Place mounting chain at an angle
across the top half of the tire. Hook anti-skid chain into
mounting hook.
Drive slowly onto the chain to complete one full turn of the
2
wheel. This will pull the chain onto the tire. Loosen mouting
hook of mounting chain out of the anti-skid chain. Remove
mounting chain.
Connect the side chain on the inside of the wheel first and
3
hook the closure hook into the ring/shackle. Then hook it to
the outside of the tire. Connect the attachment links for the
tread net.
Note: Please ensure that the strands of the chain are not
twisted!
Tighten tension chain on the outside of the wheel and insert
4
tension lever into the nearest link of the tension chain. Secure
tension lever with the ring/shakle.
Hang loose chain end into the side chain using the tension
hook.
Note: After driving a short distance (approx. 50 – 100 m or 150 –
300 ft.) stop the vehicle and re-check the tightness and fit of the
traction chain on the tire. Re-tighten the chain if necessary.
Demounting
Unhook the depositing hook.
1
Open tension lever and loosen tension chain.
2
Loosen closing hook (starting on the inside of the wheel).
3
Pull chain off of the wheel.
EN