Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
49073-1) directly behind a trailing edge dimmer. To do
this, proceed as follows:
•
Switch off the fuse of the power circuit (see figure
3).
•
Connect the dimming compensator according to
the connection diagram (see figure 4).
•
Place the device into an appropriate flush-
mounted box (see figure 5+6) or into a surface-
mounted box (e.g. Abox 025 or Abox 040) (see
figure 7+8).
•
Close the flush-mounting or surface-mounting
box using an appropriate cover.
•
Switch the fuse of the power circuit back on
again.
5.2.2
DIN rail installation
The dimming compensator can be mounted on 35 mm
DIN rails. This requires an additional mounting adapter.
The mounting adapter is available at Wago, product
reference 209-137.
To install the device on a DIN rail, proceed as follows:
•
Disconnect the power distribution panel from
the mains (see figure 3) and, if necessary, cover
any live parts (see "5.1 Installation instructions" on
page 26).
•
Remove the cover from the power distribution
panel.
•
Slide the Wago mounting adapter to the dimming
Start-up
29
Werbung
Kapitel
Inhaltsverzeichnis
