Quick Restart; Panel Lock - Disabling The Buttons On The Television; The Timer - Setting The Television To Turn On And Off - Toshiba 46WM48-Serie Bedienungsanleitung

Quick restart

When Quick restart is set to On the lamp will stay in low
power mode for several minutes after the television is
turned off, if it is then turned on from standby the picture
will appear immediately. If the Off setting is selected it may
take a few minutes for the picture to appear, during this
time clicking noises will be heard as the lamp resets, this is
not a malfunction.
In the FUNCTION menu press P or Q to
1
highlight Quick restart.
Press S or R to select On or Off.
2
FUNCTION
Teletext
Panel lock
Auto format
Blue screen
Quick restart
MENU Back EXIT Watch TV
When On is selected and the television is turned off the
screen will be dimly lit and the fans will continue to run,
this is a feature of Quick restart, not a malfunction.
If the television is put into standby whilst in this mode the
standby wattage is high, this will be dramatically reduced
if Off is selected.
Panel lock
Panel lock disables the controls on the front of the
television. All buttons on the remote control can still
be used.
From the FUNCTION menu select Panel lock
1
and choose On or Off using S or R .
When Panel lock is On, a reminder will appear
when any of the front panel controls are pressed.
Once the television has been switched off it can
ONLY be brought out of standby using the
remote control.
Quick restart, panel lock,
the timer
Auto.
Off
Off
On
On
The television can be set to turn itself On or Off after a
Press MENU and S or R to select the TIMER
1
menu.
Off timer
On timer
On timer Position
0 – 9 Set
MENU Back EXIT
Press Q to select On or Off timer. Use the
2
number buttons to set the required time. For
example, to switch the television off in one and a
half hours enter 01:30, or press R to
increase/decrease in steps of 1 minute.
If setting the Off timer, press EXIT to finish. If
3
setting the On timer, press Q to select On timer
Position, enter the programme position number
required, then press
Standby. The GREEN On timer indicator on the
front of the television will now be lit.
Any equipment connected with SCART leads must
also be put into Standby to prevent them from
being displayed when the timer switches on.
Once the On timer has been set the television
can be switched on at any time by pressing
The Green On timer indicator will remain on until
the set time period has passed, the television will
then go to the chosen channel.This feature can
help to avoid missing favourite programmes.
To cancel the On timer, enter zero in each
4
position including the programme position.
18
The Timer
certain time.
TIMER
01:30
00:00
01
Watch TV
i
to put the television into
i
.