Küppersbusch FG2500.0i Bedienungsanweisung Mit Montageanweisungen Seite 26

26
Problem
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
Temperature cannot be set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap‐
ped properly.
Temperature is set incor‐
rectly.
This is normal, no error has
occurred.
The FastFreeze function is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator is
not set correctly.
Solution
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" chap‐
ter.
The compressor starts after
a period of time.
Switch off FastFreeze man‐
ually, or wait until the func‐
tion resets automatically to
set the temperature. Refer
to "FastFreeze function"
Keep the OK button pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera‐
ture.