Servicing; Cleaning; Service Intervals; Service Kits - Parker MAXIGAS serie Handbuch

5 Servicing

5.1 Cleaning

Clean the equipment with a damp cloth only and avoid excessive moisture around any electrical sockets. If required you may use a mild
detergent, however do not use abrasives or solvents as they may damage the warning labels on the equipment.

5.2 Service Intervals

Description Of Maintenance Required
Component Operation
Generator Check status indicators located on the control panel.
System Check inlet air quality
Generator Check for air leaks
Generator Check pressure gauges during purging for excessive back pressure
Generator Check condition of electrical supply cables and conduits
Generator Check cyclic operation
Replace active exhaust silencers
Generator
Recommended Service A
Replace dust and control air filters.
Filtration
Recommended Service B
Replace/Calibrate oxygen sensor
Generator
Recommended Service C
Replace/Service valves
Generator
Recommended Service D

5.3 Service Kits

Please refer to diagram A8 in Annex A.
Service Kit
A – Silencer Service
B – Filter Service
C – O Cell Service
2
D – Valve Service
The valve overhaul (Service D) and all other repair and calibration work should be undertaken by a Parker domnick
hunter trained, qualified and approved engineer.
- Check
Description
Exhaust Silencer Kit
Filter Element Kit
PPM O Cell Kit
2
% O Cell Kit
2
PPM Valve Overhaul Kit (without
equalisation valve)
% Valve Overhaul (with equalisation valve)
18
Typical Recommended Maintenance Interval
– Replace
Kit No.
608620090
020AR
606500004
606500005