Klarfit Jumpstarter Handbuch Seite 34

EN
34
9
Repeat process for the remaining
springs. Use the spring tool, as
shown above .
Attention! Risk of injury from the
spring snapping open or shut.
11
Attach the remaining springs until all
springs are attached onto the frame.
13
Attach the cover to the trampoline
frame with all cords.
10
Springs under heavy tension may
require adjacent springs to be
attached at every four or five holes,
so the spring tension is distributed
equally.
12
Place the cover on the outer edge so
that all springs are covered.
14
After completion of the work, check
the assembly again thoroughly
before you start trampoline
jumping (see section "Testing the
trampoline").