Assembly - Klarfit Jumpstarter Handbuch

EN
32

ASSEMBLY

Note: The device is designed to be put together by two physically fit adults.
Persons involved in the assembly should wear protective footwear, gloves
and sturdy clothing.
NOTE: The following pictures show the assembly. The equipment and
appearance of the trampoline may vary slightly depending on the trampoline
model.
1
Place all trampoline parts in groups
in front of you, as shown in picture 1.
3
Slide the guide rails together to form
a circle. To close the circle, 2 persons
may be required, one person using
the last guide rail and the other
person holding the linkage on the
opposite side.
(Make sure the guide rails (A1/A2)
are correctly positioned, see step 4.)
2
Attach the leg extensions to a leg
base and secure together with the
screws. Repeat for all leg supports.
4
Assemble the circle and the
previously mounted feet as shown
above to form a trampoline frame.
Make sure that each stand is
connected to two guide rails (A1), as
shown in the picture (4) and in the
figure below.