Installation Ref. 1093/143M2; Installation Ref. 1099/204 - urmet 1093/143M2 Schnellanleitung

Privacy and Copyright
The IP camera is designed for surveillance systems. Video recording is subject to the laws applicable to the
Country where used.It is forbidden to record images with Copyright.
The User is responsible to check and respect all local laws and norms for video signal recording. The
manufacturer is NOT in any way liable for any usage of the product which might result not compliant to the
relevant norms.
Firmware upgrade
Refer to URMET S.p.A. Customer Service Technical Assistance periodically to check availability of firmware
upgrades.
Network configuration
Camera default setting is DHCP mode. If the network does not support dynamic addressing (DHCP), the device
will automatically switch to factory IP 192.168.1.168. Use Urmet "Easy Tool" software to modify the IP address
and other network settings to prevent any conflict with other devices on the network.
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the PC will be using "unicast"
connection (TCP, RTP, UDP).
The device can support up to 5 "unicast" connections so it is possible to show the video on maximum 5 remote
devices (PC or smartphone) at the same time depending on the available network band.
2

INSTALLATION REF. 1093/143M2

1 Make sure that no units are powered before starting the installation procedure.
2 Position the bracket to frame the required picture and fix it to the wall or other flat surface.
3 Connect the LAN cable from IP camera to switch or PC.
4 Power the camera.
3

INSTALLATION REF. 1099/204

1 Make sure that no units are powered before starting the installation procedure.
2 Identify the suitable position for shooting the selected images (the camera is put inside the PIR case and the images
are shot though the tiny hole on the front part).
3 In order to remove the sensor cover, unscrew and press on the fixing snap.
4 Identify the internal predispositions to fix the device and make the correct hole.
5 Once the device is fixed, put the cover on the base, screw and lock it.
6 Connect the LAN cable from IP camera to switch or PC.
7 Power the camera.
8 DS1093-597