Ip Camera Configurations; Connection To Ip Network With Dhcp Service - urmet 1093/143M2 Schnellanleitung

4

IP CAMERA CONFIGURATIONS

The camera must be configured for the home or office network after it has been powered.
It is advisable to install and configure one camera at a time if you are installing multiple cameras on the same network.
4.1

CONNECTION TO IP NETWORK WITH DHCP SERVICE

For Quick installation about IP camera with dynamic host configuration (DHCP) on the network will be assigned an IP
address automatically. IF DHCP Service is not supported, the default IP Address of IP Camera will be 192.168.1.168.
Here follow the steps for the IP Camera first installation:
1. Install the Software "Easy Tool" provided by CD and follow the installation instructions displayed at monitor.
2. Launch the "Easy Tool" Software, selecting
Subnet Mask, Gateway, and MAC Address for each IP Camera detected in LAN, as shown in picture below. In
order to display Firmware Version it is necessary to insert correct username and password
If the searched IP address and PC IP address are not in the same network segment, user may modify IP
address, subnet mask, and other parameters of IP camera by using Easy Tool software.
First select the device to modify IP address and then input new IP address, subnet mask, gateway (subnet
mask and gateway can be inherited by PC) and username/password. Click Modify Network to change IP
address of the device.
IMPORTANT NOTE
Default IP of IP camera is "192.168.1.168", username is "admin", password is "admin", media port number is
"6066" and command port "6060".
3. After detected IP Camera,push right button of the mouse and click "open in IE", and will be opened a Web
Page. If the installation of an ActiveX component is required, follow these steps.
Before connecting the PC you need to configure IE protection as follows:
From Internet Explorer Menu select Tools -> Internet Options -> Security or Protection (depending
on different Internet Explorer versions)
"Properties – Internet Protection" window will be displayed. Select "Safe websites".
Click "Websites...".
Input camera IP address in "Add website to area" and press "Add".
Please note
Do not thick "Request server check (https:) for all area websites".
Press "OK" or "Close".
Select "Customized Level" and check:
"Enabled"
o
confirmation" is selected for
"Initialize and run ActiveX
control script not marked as
safe"
"Enabled"
o
confirmation" is selected for
"Download ActiveX control
without electronic signature"
Press "OK" to confirm and close Internet
Options menu.
Install Active X from Internet Explorer.
DS1093-597
or "Ask
or "Ask
it will be displayed automatically IP Address,
9