Using The Remote; Quickpower; Sleep - THOMSON Scenium ROC10509 Handbuch

Setting Up Your Favourites, cont.
You can continue to add favourites, up to a total of 10 (you can add
more later, see page 13). At screen (6) you choose if the favourites
you just set up are stored in the group or the
can set up favourites in lots of different Groups, not just
Selecting takes you to screen (7) showing that you now have 4 set
as the first favourite in the Group (at the location next to Side
Key K1), as well as any other favourites you set up. (Note, you can
reorder, i.e., move the positions of the logos later).
When you're finished setting up your favourites, press the HOME
key (located to the left below the screen) to go back to the Home
screen.
At any time you can press the FAVORITE key and then select , or
press the key at the top left hand side of the remote to go to screen
(7) above. Then pressing the key next to the 4 logo will (in this case)
change the channel on your Cable to 4 (in this case channel 4).

Using The Remote

Assuming you followed the steps on the previous pages and have set up some devices and
some favourites you can now use the remote. See the sections that follow to set up more
devices and/or favourites, and to set up other functions.
Using the remote
Press the or key at any time to access the favourites you've set
up. Or press the FAVOURITE key, then select your favourites group.
Then press the Side Key next to the logo to change your device to
that channel. Selecting a favourite group that has not yet been set up,
takes you to the setup Wizard.
Important: Make sure you point the remote at your device until the
channel changes. Pressing a favourite key might send the commands
for say channel 162, but if you don't point the remote at your device
until all three digits are sent you might just get channel 16, or even
channel 1. Watch the flickering halo at the bottom left of the screen,
it flickers for each digit sent. It also shows what device is being
controlled.
Press the HOME key at any time to access the screen where you
can set things up, or access other features.
group. Later you
and .
10
Press the MODE key, then select a device type to change the mode that the remote is in. E.G.,
if the remote is in Cable mode then the hard keys such as Channel Up/Down, Volume Up/
(6)
Down, numbers, etc., operate your cable box.
Also, when you select a mode, any extra keys for that mode, and any keys you've learned for
that mode are displayed. The current mode that the remote is in is displayed with an icon in
the lower left of the screen. In the above example it's in TV mode. Press
your favourites screen.
Before you continue, press Side Key K5 next to the Help icon and follow the prompts to get
an idea of how to use the remote.
(7)

QuickPower

QuickPower is a way of quickly turning all your devices on or off
from one easy to use screen.
Press the HOME Key to go to the Home screen.
Then press the Side Key next to QuickPower.
Only Devices you've previously set up are displayed. The others are
grayed out.
Press any key that isn't grayed out to send the "Power" command for
that device.

Sleep

Sleep lets you set any device to turn off a preset time from now. You
can set the off time in increments of 15 minutes, up to a Maximum of
90 minutes.
Press the HOME key to go to the Home Screen, then press the Side
Key next to Sleep.
You can set a sleep timer for any or all of the devices that you've set
up, i.e., any that are not grayed out.
In this example we only have a TV, Cable Box and Satellite Receiver
set up.
Below, we pressed Side Key K1 next to the TV icon once, to set a
sleep timer of 15 minutes.
We pressed Side Key K2 next to the Cable Box icon twice, to set a
sleep timer of 30 minutes.
And we press Side Key K7 next to the Sat icon five times to set a
sleep timer of 1 hour and 30 minutes.
or to return to
11