Learning Main Keys; Learning Side Keys - THOMSON Scenium ROC10509 Handbuch

Learning, cont.
You can learn commands from an existing remote and store them under
the "Main" keys on the ROC 10509 remote, or learn commands from
an existing remote and store them under any of the 10 Side Keys.
At the Home screen press the Side Key next to Setup and then on the
side key next to Learn.
At this screen you press any of the 5 Side Keys K1-K5 on the left to
learn commands under a Side Key, or press any of the top 4 Side
Keys K6-K9 on the right to learn commands under the main keys on
the remote.
If you press a right Side Key (to select Main Keys) you are going to learn, say, the Prog Up
key from an existing remote and store it under the Prog Up key on the ROC 10509 remote.
Or learn the Power key from an existing remote and store it under the Power key on the ROC
10509 remote, etc.
If you press a left Side Key (to select Side Keys) you are going to learn, say, the "DVD
Zoom" function from an existing remote and store it under a Side Key on the ROC 10509
remote. You will then be able to name the key "DVD Zoom" and access this "DVD Zoom"
function from the Mode screen when the remote is in the mode that you selected when you
learned this "DVD Zoom" command.

Learning Main Keys

At the Home screen press the Side Key next to Setup and then on the
Side key next to Learn.
Then press one of the top 4 Side Keys K6-K9 to the right of the
screen.
22
Select the Device you want to learn keys for. In this example we
only have a TV, Cable Box and Satellite Receiver set up, so the rest
are grayed out, but you can still select any of the devices to learn
commands for. You are then instructed to line up the remotes, and
press the key on the ROC 10509 remote that you want to learn.
You then point the remote you want to learn commands from at the
bottom of the ROC 10509 remote, and press the key on the ROC
10509 remote that you want to learn a command under, e.g., the
Power key.
You then press and hold (in this example) the Power key on the
other remote, until the display shows that the command has been
successfully learned. Note for some types of key you might need to
hold the key pressed, but for other types a quick press is sufficient.
Experiment a bit. If keys you learn are sent multiple times try learning
them with just a quick press. (See Tips on Learning on page 21).
If the screen says Failure, you can press the key and try again.
You can continue learning more individual keys by following the
instructions on the screen, and then press Done when you're finished.

Learning Side Keys

At the Home screen press the Side Key next t to Setup and then on the
Side key next to Learn.
Then press any of the Side Keys K1-K5 to the left of the screen.
23