Installation Instructions - Atag Cafemax CM4111 Anleitung

YOUR COFFEE MACHINE
PROBLEM CAUSE
Ground coff ee was used Th e "coff ee strength/
(instead of coff ee beans) preground coff ee" knob is
and the machine will not not turned completely to
dispense any coff ee. the left
and the appliance used
both preground coff ee and
coff ee ground by the mill
mechanism.
Preground coff ee was inserted
whilst the machine was
switched off .
Coff ee does not come out Th e holes on the coff ee
of the spouts on the coff ee dispenser are blocked with
dispenser but out of the dried on coff ee.
service door at the side.
Th e swing drawer on the
inside of the service hatch is
blocked and will not move.
Milk is frothed up too much Wrong setting of the slider on
or too little. the lid of the milk container.
If the milk is not frothy
enough, the milk container
may not be correctly in place.
GB 34
8 Faults
SOLUTION
Carefully clean the inside of
the machine (see page 12).
Repeat the process, but fi rst
or right turn the "coff ee strength/
preground coff ee" knob
completely to the left
right (see 5.2.5 on
page 14).
Remove the brewing unit and
carefully clean the insided of
the machine (see 6.1.1 and
6.1.2 on page 21, 22 and 23).
Repeat the process with the
machine switched on.
Remove the dried on coff ee
with a needle (see 6.1.1 on
page 21, fi g. 24).
Carefully clean the swing
drawer, particulary in the area
around the hinges so that
these continue to move.
You can set the amount of
froth on the milk to any
level using the slider on the
lid (fi g. 19 on page 17):
'CAPPUCCINO' (very frothy
milk) or 'CAFFELATTE'
(not so frothy milk).
Put the milk container
correctly in place. (fi g. 18 on
page 17).
YOUR COFFEE MACHINE
9.1 Important matters
or

9 Installation instructions

• After removing the packaging, make sure the product is complete
and undamaged. If in doubt, do not use the appliance and contact
a qualifi ed professional.
• Installation must be carried out by a qualifi ed techncian and in
compliance with current regulations.
• Packing elements (plastic bags, polystyrene etc.) must not be left
within reach of children as they may represent a hazard.
• Never install the appliance in environments where the
temperature may reach 0 °C or lower (the appliance may be
damaged if the water freezes).
• Make sure the mains voltage corresponds to the voltage indicated
on the appliance rating plate. Connect the appliance to an
effi ciently earthed socket with a minimum current rating of 10A
only. Th e manufacturer may not be considered liable for possible
incidents caused by the failure to adequately earth the mains.
• If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualifi ed
professional.
• Th e power socket has to remain visible after installation.
• Do not use multiple plug adapters or extension leads.
• Th e power cable on this appliance must not be replaced by the
user as this operation requires the use of special tools. If the cable
is damaged or requires replacing, contact an authorised service
centre only to avoid all risks.
• For the electrical connection use a HO5 VV-F type cable as
indicated in the table below:
Conductors Amount x size
230 V ~+ ~ 3 x 1.0 mm 2
• You should personalise water hardness as soon as possible
following the instructions in 6.2.2 on page 24 and 25.
GB 35