Nikon Lite Touch Zoom 130ED Bedienungsanleitung Seite 43

Problem
No indicator
appears even
when the camera
is turned on.
The numeral " "
does not appear
even when film is
loaded.
The shutter
cannot be
released using
the remote
control.
When the battery is replaced or re-installed, the date and time you set are cleared.
*
Reset them. (
A characteristic of electronic cameras
In certain cases, due to static electricity, the Lite Touch Zoom
130ED/Lite Touch Zoom 130ED QD microcomputer may turn the
camera off, even with fresh, properly installed batteries. For the
same reason, the film may not advance properly. In each of these
cases, to resume operation, simply turn the power off, then turn it
on again. Or, remove and reinstall the batteries.
When the battery is removed, the date/time you set are cleared.
Reset them after reinstalling the battery. (
Check points and solution
a The battery is installed the wrong way round.
Insert the battery with the + and – ends
positioned as marked inside the battery
*
chamber.
a No battery or dead battery.
Install a new battery.
a " " blinks or lights up.
Remove the film and load it again.
a You are out of the remote control working range.
Operate the remote control in a range within
5m facing the camera.
a Two or more minutes have elapsed since you set
the camera to Remote Control mode.
Set the camera to the Remote Control mode
again.
a The remote control is operated in backlit.
Change the position of the remote control.
a The service life of the battery in the remote control
has lapsed (5 years).
Install a new battery.
p. 41)
*
p. 41)
Additional Information
Ref. page
14
14,15
16,17
39
E
39
39
40
43