Specifications - Makita BHR162 Betriebsanleitung

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Switch trigger
6. Lamp
7. Reversing switch lever
8. Lock button
9. Rotation with hammering
10. Action mode changing knob
11. Rotation only

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS ROTARY HAMMER
SAFETY WARNINGS
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
Explanation of general view
12. Grip base
13. Side grip
14. Loosen
15. Tighten
16. Teeth
17. Protrusion
18. Bit shank
19. Bit grease
20. Bit
21. Chuck cover
22. Depth gauge
Model
Concrete
Steel
Wood
-1
)
Net weight
metal parts of the power tool "live" and could give the
ENE042-1
operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
GEA010-1
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
GEB046-2
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
23. Dust cup
24. Blow-out bulb
25. Chuck adapter
26. Keyless drill chuck
27. Sleeve
28. Ring
29. Limit mark
30. Holder cap cover
31. Recessed part
32. Brush holder cap
33. Screwdriver
BHR162
16 mm
13 mm
24 mm
0 - 1,500
0 - 5,000
296 mm
2.4 kg
D.C. 14.4 V
5