Change The Printable Area Settings - Rimage 2000i Benutzerhandbuch

Disc with stacking ring
Tip: Most discs with a
printable hub and a stacking
ring have the following
printable areas:
Standard Area
Hub Area
Disc without stacking ring
Tip: Rimage recommends
that you set the inner
diameter so that it is 1 mm
greater than the actual
measurement to prevent the
ink from smearing. The inner
diameter on Rimage media
is 23 mm. Set the inner
diameter field to 24 mm.
110763_I
Downloaded from www.Manualslib.com
Outer Diameter 118 mm
Inner Diameter 38 mm
Outer Diameter 35 mm
Inner Diameter 24 mm
manuals search engine

Change the printable area settings

This functionality allows you to adjust the non-printable area, or mask,
settings for standard CD/DVD 120 mm media. This allows you to set
the outer and inner diameters to print the disc without overlapping the
disc edges. If you print on areas of the disc where the surface is not
suitable for printing, the ink can smear or run.
1. Navigate to Printing Preferences. Refer to page 8.
2. Change the printable area settings.
a. Select the Mask Settings tab.
b. Select the Enable Masking checkbox.
c. To print on the disc hub, in the Hub Area Settings box, select
the Printing on Hub checkbox.
3. Measure the printable area and adjust the settings.
9. If you are using hub printable discs with a stacking ring:
a. Measure the inner diameter of the printable surface.
b. In the Hub Area Settings field, enter the inner diameter
that you measured in step a.
c. Measure the outer diameter of the printable hub area.
d. In the Hub Area Settings field, enter the outer diameter
that you measured in step c.
e. Measure the inner diameter of the standard printable
area.
f. In the Standard Area Settings field, enter the diameter
that you measured in step e.
10. If you are using a disc without a stacking ring:
a. Measure the inner diameter of the printable surface.
b. In the Hub Area Settings field, change the Outer
Diameter and Inner Diameter settings to the value
measured in step a before changing any other diameter
settings.
c. In the Standard Area Settings field, change the Inner
Diameter to the same value used in step b.
4. To use your changes, select Apply.
5. To close the Preferences window, select OK.
Operate the Rimage 2000i
11