Replace The Ink Cartridges - Rimage 2000i Benutzerhandbuch

Replace the ink cartridges

Use this procedure to change the ink cartridges on your Rimage 2000i.
1. Lift the ink cartridge access door. The ink
cartridge carriage moves to an accessible
position on the carriage guide.
2. When the ink cartridge carriage is still, lift the
ink cartridge latch to the open position.
3. If an ink cartridge is already installed, slide
the ink cartridge out of the ink cartridge
cradle.
4. Remove a new ink cartridge from its
packaging and carefully remove the
protective tape that covers the ink nozzles.
5. Hold the ink cartridge so that the copper
strip is on the bottom and facing toward th
printer a
cradle.
6. Push down on the ink cartridge latch until it snaps closed.
7. Close the ink cartridge access door. The ink cartridge status light flashes for a few seconds and then
stops flashing. The Rimage 2000i is ready to print.
8. Align the ink cartridges. Refer to the Aligning the ink cartridges procedure on page 12.
110763_I
Downloaded from www.Manualslib.com
Important! You must use the appropriate ink cartridges in one of the configurations listed in the 'Ink
Requirements' section. Refer to page 1.
I mportant! Do not touch the no
the copper contacts on the ink
cartridges. If you touch these parts,
clogs, ink failure, and poor electrical
connections are likely to oc
remove the copper strips.
nd slide the ink cartridge into the
Note: If the ink cartridge is not securely seated in the cradle, the printer will not recognize the ink
cartridge. The printer may not reset properly or you may receive an "invalid ink cartridge" message.
If this happens:
•
Remove the cartridge and firmly reinsert it.
•
Make sure you are using the appropriate cartridge. Acceptable cartridges are listed in the
requirements' section on page 1.
•
If the problem persists, replace the cartridge.
manuals search engine
Ink cartridge latch
zzles or
cur. Do not
e
Maintain the Rimage 2000i
'Ink
19