Clamping PushBuddy
Make sure that the PushBuddy
switch is activated. If you need light to insert the PushBuddy
The LEDs will stay on for ten seconds.
Clamping into a pipe
Hold the PushBuddy
and position it in such a way that both
granule coated parts of the clamping
machanism are inside the pipe.
Push the rocker switch forward and
keep it pressed. The clamping mecha-
nism expands and switches off auto-
matically when the PushBuddy
engaged. The LED fl ashes. Release the
rocker switch.
44
at the beginning of a pipe
®
is connected to the base unit and that the emergency stop
®
by the handle
®
is fi rmly
®
, press the rocker switch briefl y.
®
Clamping to a pipe wall
Hold the PushBuddy
by the handle and
®
position it in such a way that the pipe
wall is between the two granule coated
parts of the clamping machanism.
Push the rocker switch backwards and
keep it pressed. The clamping mecha-
nism closes and switches off automati-
cally when the PushBuddy
engaged. The LED fl ashes. Release the
rocker switch.
is fi rmly
®
EN